Price: 1.63 - 2.00
Product name: TMC2209
Maximum output current: 2A
Recommended working current: maximum 1.7A
Microsteps: 256 microstep subdivision
Configuration: STEP/DIR OR UART
Load driving range: 5.5~38V
IC logic working voltage: 3/5V
Note: The default support is for non jumper UART mode, which can be ignored if not used.
TMC2208 V1.3
Delivery list:
Tmc2208 driver module, 1 piece
Heat sink, 1 piece
Potentiometer adjusting screwdriver, 1 piece
characteristic:
Single phase current of 1 two phase stepping motor 1.2A (peak value is 2.0A ）Adjustable motor 2 supports two control modes: step / dir interface and SPI interface
3. Input voltage range of motor: four point seven five -36V
4. Input voltage of logic interface: 3-5v
5 subdivided into 256
6. No noise operation combined with efficiency and motor torque
7 high precision sensorless motor load detection
8. Reduce energy consumption by 75%
9. High load drive without out of step
Tmc2208 single axis stepping motor driver chip, power tube built-in drive current 1.4A Peak current 2a, voltage range
4.75V -36V, 256 subdivision; with patented technology spreadcycle Gamma High chopping frequency, dcstep Gamma Locked rotor detection technology, coolstep Gamma Current dynamic regulation technology can save 70% energy, steadthchop is silent
Flexible microplyer interpolation unit, components can provide resolution up to 256 microsteps / step, even at pulse speed
In the system with limited rate, sinusoidal control can still be realized; because the stealthchop technology is widely used in 3D printing
Therefore, the design of these components is also compatible with the existing 3D printer electronic equipment, saving the expensive cost of redesign
Use. Both components have pulse / direction input and can operate independently. Configuration is achieved by digital input.
Can replace the original tmc2100 with lower heat output, especially suitable for 3D printing market!!!
